Finishing up the pendants and the earrings. Cleaaned and dipped into Permalac EF sealer then hung to dry then assembled with copper jump rings and Niobium ear wires
18g copper solder stamped 
Brass solder stamped 
Permalac EF dip to seal
Microscope Slide Pendants
I created prints that will fit the microscope slides Used copper foil tape to hold them together Flux is applied to the copper tape then the solder is applied I added jump rings to top and bottom You can patina or leave plain I added a crystal T fhe bottom
Stamping Solder
Clean your copper or brass and apply liquid flux Melt a pool of solder and use a red stamp ( high temp rubber stamp) to press into the hot sold Wait a moment for it to harded and peel off stamp You can remove extra solder by jyst running the solder tip around edges Let cool and then patina
The itemsbeliw are either brass or copper no patina yet
Subscribe to:
Posts (Atom)