I took one of the pieces - the ends are pretty rough - the piece was cut at the metal supply place
rough and sharp
to quickly clean the edges I used my grinder
cleaned up fast on the grinder
hardly had to to do any work - ground it flat on top - then angled the sides so that it was more pointed - now its in my vice - note \i am using some foredome foam edged so they dont dig into the metal so I can go to the next stage -
I need to find my fine tip sharpie so I can draw the design - ( I want to do a flower )
but that may not happen till next week -
No comments:
Post a Comment